hello all
![yes]( "yes")
we have just explained to you a problem encountered on a
mini R50 1.6 16V 2004
ecu siemens ref:
s118012001L
216214485
05161
we have a problem with cilyndre 1 and 4 ignition we have no ignition at the levels of the ignition coil
the vehicle starts but runs on two cylinders 2 and 3.
the last owner, we change the clutch before the car arrival with us with this problem.
with diag interface (launch x431 and delphi ) we have many faults concerning ignition and ecu.
we have k+dcan interface but im not ok with install at this time....
having done some research on the internet concerning this vehicle, some person we had electronic problems after changing the clutch or gearbox.
we have checked the beam from the ecu to the ignition coil but no fault or cut is to be noted on this side.
we have checked and cleaned the pmh sensor angle sensor and all that we can verify is no real problem to note on this side.
by continuing our research we finally opened to see interrior of ecu.
we found that the ecu had already been opened
we have a little part of the flexible pcb which has a cut at the level of the circuit which probably causes a problem
we intend to change the calculator. we have in our possession another calculator but is littlebit different in level of numbers
the ref is :
S118012001L0
226055580
05795
Do you think that it is possible we use this ecu ?
how to make an immo off ( if is possible ) ?
or do you know a way to be configure the second ecu on the car?
whats we need use of tool for make this job u think?
we have
launch x431
delphi
ista (if i arrival to install
![tears]( "tears")
)
kess v2
ktag
carprog
thank you for your future help and thank you to all those who keep the forum alive
I wish you all a good evening.
)
![[Image: IMG-7100.png]](http://i.postimg.cc/YGfH2p9b/IMG-7100.png)