Looking for help/guidance with resolving an issue.
I updated VSGG83 ECU on E83 using WinKFP and K-DCAN, now I am seeing ABS, Brake and 4x4 lights on dashboard. Car drives fine.
ISTA+ says there is a coding error so I installed ISTA-P 3.66.1 with 6.1F loader with hope to do the coding there. Unfortunately I can't seem to connect even with ICOM emulator activated.
Thoughts:
- INPA doesn't have a job list option for E83 so I don't have the list of modules. I picked the highest ZB-Number 7599883 to flash in WinKFP, could that be an issue or would any ZB-Number work? I assumed higher is better.
- In ISTA-P Loader I went through installing patched EDIABAS 7.3 + run K-DCAN network config tool. Still no connection with K-DCAN cable.
- VTG module status in INPA+ sometimes shows module grey, sometimes orange. Doing ECU tests tells me ECU is working properly.
What do you recommend I do next?
Some screenshots attached.
I updated VSGG83 ECU on E83 using WinKFP and K-DCAN, now I am seeing ABS, Brake and 4x4 lights on dashboard. Car drives fine.
ISTA+ says there is a coding error so I installed ISTA-P 3.66.1 with 6.1F loader with hope to do the coding there. Unfortunately I can't seem to connect even with ICOM emulator activated.
Thoughts:
- INPA doesn't have a job list option for E83 so I don't have the list of modules. I picked the highest ZB-Number 7599883 to flash in WinKFP, could that be an issue or would any ZB-Number work? I assumed higher is better.
- In ISTA-P Loader I went through installing patched EDIABAS 7.3 + run K-DCAN network config tool. Still no connection with K-DCAN cable.
- VTG module status in INPA+ sometimes shows module grey, sometimes orange. Doing ECU tests tells me ECU is working properly.
What do you recommend I do next?
Some screenshots attached.
| ZB-Number.JPG | ||
| File Type: |
|
 |
| Downloaded: | 2 times | |
| Size: | 44.17 KB | |